Kingston

Kingston ValueRAM 4GB (1x 4GB) DDR3 1333MHz Memory

Product ID:
160084
SKU:
KVR13N9S8/4
Availability:
Out of Stock - Contact for ETA
Use the above Product ID when contacting us
$60.00 inc GST


Description

ValueRAM's 512M x 64-bit (4GB)
DDR3-1333 CL9 SDRAM (Synchronous DRAM), 1Rx8  memory
module, based on eight 512M x 8-bit DDR3-1333 FBGA components. The SPD is programmed to JEDEC standard latency
DDR3-1333 timing of 9-9-9 at 1.5V. This 240-pin DIMM uses
gold contact fingers. The electrical and mechanical specifications are as follows:

FEATURES
 
• JEDEC standard 1.5V (1.425V ~1.575V) Power Supply
• VDDQ = 1.5V (1.425V ~ 1.575V)
• 667MHz fCK for 1333Mb/sec/pin
• 8 independent internal bank
• Programmable CAS Latency: 9, 8, 7, 6
• Programmable Additive Latency: 0, CL - 2, or CL - 1 clock
• Programmable CAS Write Latency(CWL) = 7 (DDR3-1333)
• 8-bit pre-fetch
• Burst Length: 8 (Interleave without any limit, sequential with
starting address “000” only), 4 with tCCD = 4 which does not
allow seamless read or write [either on the fly using A12 or
MRS]
• Bi-directional Differential Data Strobe
• Internal(self) calibration: Internal self calibration through ZQ
pin (RZQ : 240 ohm ± 1%)
• On Die Termination using ODT pin
• Average Refresh Period 7.8us at lower than TCASE 85°C,
3.9us at 85°C < TCASE < 95°C
• Asynchronous Reset
• PCB: Height 0.740” (18.75mm), single sided component

SPECIFICATIONS
 
CL(IDD): 9 cycles
Row Cycle Time (tRCmin): 49.5ns (min.)
Refresh to Active/Refresh: 260ns (min.)
Command Time (tRFCmin)
Row Active Time (tRASmin): 36ns (min.)
Maximum Operating Power: 2.100 W*
UL Rating: 94 V - 0
Operating Temperature 0 degree to 85 degree
Storage Temperature -55 degree to +100 degree
View AllClose

Additional Information

productid:
160084
View AllClose